Plastic packaging barrels are commonly used in our lives, but the most headache for us is the problem of variability, so how should we prevent it?
First, the outer cover needs to be tightened (usually with the help of external force such as a wrench). After the sealing ring is installed, it should be close to the contact surface of the barrel to avoid the sealing ring from being distorted and installed. If the temperature of the filled product is higher than 40°C, it must be capped and stacked after the product has cooled. When stacking, pay attention to ensuring flatness. The upper base layer should have a large contact area and the upper base layer should be aligned. Do not stack the stack in a dislocation to avoid deformation of the plastic bucket.
The weight or specific gravity of the dangerous goods contained in the chemical barrels shall not exceed the larger weight or specific gravity of the contents that can be carried. Do not use low-hazard plastic drums for dangerous goods that require high-category packaging. If it is shipped in plastic drums without vents, it will release gas during storage and transportation. The weight or volume of a single piece of dangerous goods contained in the barrel shall not exceed the high limit of the world rules for the transportation of dangerous goods. During loading, unloading and transportation, you should avoid falling and avoid bumping with hard and sharp objects. When loading dangerous goods, do not corrode or damage the appearance of the plastic drum.
First, when filling, check whether the lid and body of the plastic bucket are matched products. Otherwise, the unmatched fusion of the lid and the body may cause the liquid to leak from the mouth. The liquid temperature cannot be higher than 70°C. The storage should be protected from light, the temperature should be below 40℃, and the temperature should not exceed 25℃ during shipment.
After filling the high-temperature liquid, the plastic packaging barrel should not be loaded and transported immediately. Please do not drag the chemical barrel directly on the ground during the transportation of the filled liquid, so as to avoid abrasion and bumps on the bottom. The correct method should be to lift it with two hands or use a forklift wooden pallet.
https://www.fhpails.com/
