Plastic Buchet for Latex paints are made of polyethylene, polypropylene, etc. as raw materials for blow molding and injection molding. Safe use of plastic barrels: If the filling product is prone to form volatile gas, it should be filled at a time when the temperature is very low during the day, so as to avoid the concave image. The outer cover of the plastic barrel should be tightened by external force. After the sealing ring is assembled, it must be in close contact with the contact surface of the barrel mouth. It is forbidden to distort the sealing ring. If the temperature of the filling product is higher than 40 °C, the filling and tightening of the outer cover and stacking must be carried out when the product temperature is cooled to room temperature. When stacking, attention should also be paid to the stacking level, the contact area between the upper and lower layers of the stacking should be kept large, the upper and lower layers should be aligned, and misplaced stacking is prohibited. For the residue on the chemical plastic bucket, you can use soap to add a small amount of ammonia water to remove the residue, which can make the surface of the chemical plastic bucket more shiny. Use the heat seal of the hair dryer to soften the residue on the Wuxi chemical plastic barrel, and when the viscosity of the residue becomes smaller, it can be easily removed. You can use an eraser to wipe on the edge of the chemical plastic bucket, which can easily remove marks. For the different viscosity of the residue, the required scrubbing time will also be different. If there is alcohol, the effect of cleaning after use may be better.
